Troubleshooting and repair of Taishan infrared burner
Fan motor fault
Fan does not work, fan capacitor fault check, replace, repair air supply pipeline did not open the manual valve, open the air supply pipeline manual valve air pressure switch fault
Poor touch or damage of burning needle and thread leads to leakage inspection, isolation and repair
The position of the burning rod is not adjusted properly, the burning interval is 4-6 mm, the burning controller is not checked, replaced and repaired, the fan works but does not burn, the air pressure switch is faulty, the fan volume is too large, the air volume share is adjusted, the burning is not successful, and the gas is not delivered
1. There is something wrong with the solenoid valve
2. Check, adjust and replace the blocked air supply pipeline, adjust the air volume share when the fan volume is too large, and touch the flame detection rod with the burning surface or the body of the incinerator.
The gap between the flame detection rod and the burning surface is 6-10mm to ensure that there is no touch between the flame detection rod and the body of the incinerator. The orientation of the flame detection rod is bad, as above. The wire of the flame detection rod is bad. It is inappropriate to check and replace the air and gas share, adjust the air volume, adjust the outlet flow of the solenoid valve, and the burning controller is bad.
Article source: Taishan infrared burner http://m.nd7.com.cn
-
05-28
Infrared furnace head manufacturer: what is ceramic infrared heater?
The ceramic infrared heater is composed of resistance thermal conductor embedded with appropriate ceramic materials. Because all of them are embedded in the ceramic, the energy generated by the thermal conductor can be transmitted to the surrounding materials, which can not only avoid overheating of the thermal conductor, but also extend its service life. The data used for embedded thermal conductors need to be insulated and have good absorption and radioactivity within the set range of infrared
-
05-28
How to install infrared ceramic chip for infrared burner manufacturer?
The bonding of infrared ceramic chips usually includes cleaning, drying, bonding, drying, sintering and other steps. 1. Tank cleaning. The tank which needs to replace ceramic chips is dirty, which will affect the quality of incineration and the firmness of bonding. It needs to be cleaned after full soaking (recommended time is 24 hours). It can be cleaned with steel ball, screw driver, toothbrush, test tube brush and other things.
-
05-28
What are the advantages of Taishan infrared burner?
Advantages of Taishan infrared burner: 1. Oil stove, smoke, save gas, do not back the black pot. The real Taishan infrared burner is the technology of flameless ignition. There is no fire on the surface, but there is enough ignition. Basically, there is no smoke. It is more physically and mentally healthy in the whole process of application at home
-
05-28
What does Taishan infrared stove rely on for heating?
1. We know that the infrared gas stove is not heated by fire, but by the infrared radiation source. The milky white set pot will reflect the radiant heat of the surface and form less heat for digestion and absorption. The objects around the stove are likely to be burnt out. That is to say, the longer the tone of the set pot, the more suitable the infrared gas stove is. The milky white set pot can digest and absorb the radiant heat at least.